Jump to content

UM2 pre or post 2014?

Kenross1951

By Kenross1951
in UltiMaker 3D printers

 Share

Recommended Posts

Slashee_the_Cow

Slashee_the_Cow 279

Posted
Posted · UM2 pre or post 2014?

You can't move it. Just create a new topic there (better option) or wait for a mod to move it. And if you create a new topic there, just post in this one saying that's what you did so the mods know to delete this one.

  • Like 1
Link to post
Share on other sites
Kenross1951

Kenross1951 2

Posted
  • Author
Posted · UM2 pre or post 2014?

Posted in Printer's Section pls delete from here

    • Link to post
    Share on other sites
    Guest
    This topic is now closed to further replies.
     Share
    Followers 2
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 26 replies
        MariMakes

        Picked By

        MariMakes,

      • Release Notes: S-Line Firmware 8.3.0 (Latest)

        Dustin posted a topic in Firmware,

        S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...