Jump to content

Verkaufe Ultimaker 3D Drucker Raum Wien Umgebung

Smithy

By Smithy
in Deutsch

 Share

Recommended Posts

Smithy

Smithy 1,144

Posted
Posted · Verkaufe Ultimaker 3D Drucker Raum Wien Umgebung

Wegen einer Neuorientierung benötige ich Platz und trenne mich schweren Herzens von ein paar Ultimaker Druckern.

 

  • Ultimaker 3
  • Ultimaker 2+Connect
  • Ultimaker S3
  • Ultimaker S5 mit Airmanager
  • Ultimaker 2Go

 

Alle Drucker sind in einem 1A Zustand, wurden regelmäßig gewartet und haben auch eine Menge Zubehör, wie Printcores, Filafarm Switchplates, zusätzliche Glasplatten etc. Es sind auch noch tonnenweise Filamente vorhanden.

 

Bei Interesse bitte via PM melden.

Die Drucker werden nicht verschickt und müssten selbst abgeholt werden. Standort Wien bzw. 3001 Mauerbach.

    • Link to post
    Share on other sites
    • Smithy locked this topic
    Guest
    This topic is now closed to further replies.
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 20 replies
        MariMakes

        Picked By

        MariMakes,

      • Release Notes: S-Line Firmware 8.3.0 (Latest)

        Dustin posted a topic in Firmware,

        S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...