Does the printer select have the specific printer dimensions pre loaded?
Go to solution
Solved by Slashee_the_Cow,
-
Our picks
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 3 replies
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Picked By
MariMakes, -
-
UltiMaker Cura 5.7 stable released
ArunC posted a topic in UltiMaker Cura,
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
-
-
- 26 replies
Picked By
MariMakes, -
-
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Recommended Posts
Slashee_the_Cow 303
If you added the printer through the Add Printer wizard in Cura, then the print bed dimensions should be correct and you don't need to do anything.
Why, does something not seem right?
Link to post
Share on other sites
Mangolemmon 0
Oh ok, I wasn't quite sure so I wanted to verify just in case. Thank you!
Link to post
Share on other sites