UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
There is a post processor called "Search and Replace". You would need two instances.
Search = M204
Replace = M8008
and
Search = M205
Replace = M8007
Those will work as long as the units are the same and the parameters are the same. Cura will use the S parameter for Accel. Other parameters for Accel would be X and Y for each axis or P and T for print and travel. You might have to get fancy with the regular expressions if there are numbers between the parameters.
Jerk is by axis so it always uses X Y parameters.
I think Search and Replace will start at the first layer (raft or model) but you'll need to check to make sure.
Search = M204 S(\d*)
Replace = M8008 P\1 T\1
Use Regular Expressions = checked
would go from
M204 S1000
to
M8008 P1000 T1000
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
Recommended Posts
GregValiant 1,305
There is a post processor called "Search and Replace". You would need two instances.
Search = M204
Replace = M8008
and
Search = M205
Replace = M8007
Those will work as long as the units are the same and the parameters are the same. Cura will use the S parameter for Accel. Other parameters for Accel would be X and Y for each axis or P and T for print and travel. You might have to get fancy with the regular expressions if there are numbers between the parameters.
Jerk is by axis so it always uses X Y parameters.
I think Search and Replace will start at the first layer (raft or model) but you'll need to check to make sure.
Search = M204 S(\d*)
Replace = M8008 P\1 T\1
Use Regular Expressions = checked
would go from
M204 S1000
to
M8008 P1000 T1000
Link to post
Share on other sites