3 hours ago, Slashee_the_Cow said:I think you gotta stick to regular filaments 😄
Looking at the last picture, it's possible that the support is close enough that it's not doing a retraction when it moves from the support to the model. You can try changing Travel > Retraction Minimum Travel to something really low (like 0.1mm) to try and make it retract all of those bits.
Thanks for reply
Sticking to regular filaments is a no go 😁
This is a hot seller.
I was thinking in the same direction, i tried retract at layer change, but no difference.
Next time i will try to decrease the distance, i keep you posted
Recommended Posts
Slashee_the_Cow 416
I think you gotta stick to regular filaments 😄
Looking at the last picture, it's possible that the support is close enough that it's not doing a retraction when it moves from the support to the model. You can try changing Travel > Retraction Minimum Travel to something really low (like 0.1mm) to try and make it retract all of those bits.
Link to post
Share on other sites