Are you sure? It sounds like a loose pulley. Did it move in only one axis such as only X or only Y? If so one of the 6 pulleys on that particular axis has a set screw that isn't tight enough. You can just tighten all 6 or just the 2 on the short belt as that one is most likely the problem or you can use a permanent marker and mark each pulley and shaft so if it moves again you can see which one isn't tight enough.
Recommended Posts
missspiff 0
problem solved. I downloaded 14.03 test2 and I've got a nice bracelet again! :-P
Link to post
Share on other sites