Thanks for the fast response. I adjusted the buildplate and the result came out much better. Thanks.
Thanks for the fast response. I adjusted the buildplate and the result came out much better. Thanks.
@ecflam: After you've completed the bed calibration as per Nicolinux's suggestion, check that the brim prints well (it should be very slightly flattened). If it's not perfect, stop printing, recalibrate the bed once more and try again.
Recommended Posts
Nicolinux 288
Hi,
you should re-level the bed. (UM2 menu -> advanced, build plate). Make sure the gap between the nozzle and the bed is very small. When the bed and the nozzle are cold and you slide a piece of paper between them, you should feel very very little resistance.
Link to post
Share on other sites