Hot-end Cooling Fan 5VDC 0.08A

[mark-hale 1]

Hi

Does anyone know the full specifications for the Hot-end Cooling Fan 5VDC 0.08A on the Ultimaker 2.

After a filament block (why does this happen when im not around) the rear fan got well and truly covered in PLA and despite managing to clean the plastic I think it suffered an overheat and is now failing.

Have had a look on the store but this doesn't seem to be available, had a look at the BOM but need to know the exact specs so I can look to get a replacement.

I have also emailed support to see if its available direct from Ultimaker.

Cheers

 

[Dim3nsioneer 558]

I replaced mine with an ebmpapst 255N. It's a bit pricy but very silent!

 

[mark-hale 1]

I replaced mine with an ebmpapst 255N. It's a bit pricy but very silent!

 

Excellent - did this come with the connectors or just straight wire, just did a quick search and came across http://uk.mouser.com/ @£14 so yes expensive but tempted to cut down on the noise if replacing. .

 

[Dim3nsioneer 558]

I had to mount the connector by myself.

[mark-hale 1]

thanks