Ha I got a new teflon glass piece couple of days ago.
Took apart the head again, to check the new piece after a couple of days and there are scratches but it moves nicely.
Printing at 0.2mm at 50 mm/s
I thought even it would be the brand new filament I got, last weekend I printed super with bronzefill. Now it's back to the same old problems.
Printing the Ultimaker Robot on different temperatures, the 210 C was not so pretty, the 200 C is looking a bit better but same problem in same areas.
The horror...
Recommended Posts
gr5 2,224
There's lots of possibilities. What speed and layer height are you talking about?
One likely possibility - take apart the head and the white teflon piece that touches the nozzle could be deformed - take that out and slide some filament through it to see if it is sliding nicely. If not you might need to drill it out with a 3 or 4mm drill bit.
Another possiblity - your 3rd fan stopped working - sometimes the wires fall out of the connectors when the head moves around. Make sure it is working - the fan in the back of the print head (not the side 2 fans).
But what layer height/speed are we talking about here?
Link to post
Share on other sites