Jump to content

Can this cause delamination?


thomas-roager

Recommended Posts

Posted · Can this cause delamination?

Is that a "hole" all the way through the filament? If so, I'd send it back and demand a full refund. It's going to cause problem with under extrusion. The calculated volume of plastic will be completely wrong since all the slicers assume that the filament is solid all the way through. Sure, you could tweak your settings until the volume matches what it's supposed to be but you shouldn't have to. Plus, you're getting less plastic than you paid for.

 

  • Link to post
    Share on other sites

    Posted · Can this cause delamination?

    well i have used around half the spool and havent had 1 successful print yet. and reprapworld says that it isnt what caused the problem. and now i see why i get a wrong layer if i have this hole in the filament ?

     

  • Link to post
    Share on other sites

    Posted · Can this cause delamination?

    Even if it wasn't what caused your problem that's still shitty quality and they know it, they just want to get away with it. You should still demand a refund IMHO. If they're serious about their business and value their customers they should make it right.

     

  • Link to post
    Share on other sites

    Posted · Can this cause delamination?

    ABS? PLA?

    Just increase flow by 20%?

    Delamination is rare in PLA. Is this ABS?

     

  • Link to post
    Share on other sites

    Posted · Can this cause delamination?

    ABS and i have tried but Then i get very visible layers not the pretty ones. And im using 270 degrees c and even at 275 it isnt working. I Can extrude at 220 degrees c

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
    ×
    ×
    • Create New...