Jump to content
Ultimaker Community of 3D Printing Experts
Sign in to follow this  

Rusted Bed?

Recommended Posts

I've only had my Ultimaker 2 for a couple of weeks now. At some point a brown spot appeared in the middle of my printer bed. I think it's rust, but I am not certain. I may have gotten some water on there or something. Has anyone had this problem? What is the best way to clean this?

Also, I have a picture of the problem, but how do I post pictures to the forum?


Share this post

Link to post
Share on other sites

You should be good to go for image uploads as far as I can see. Usually what stops people is that they haven't validated their e-mail account, but it looks like you've done that.


Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  


Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!