Jump to content

"un-original" fans not working

magnusrm

By magnusrm
in UltiMaker 3D printers

 Share

Recommended Posts

magnusrm

magnusrm 0

Posted
Posted · "un-original" fans not working

Hi.

I had a crash with the Ultimaker 2, which ruined both the fans. I ordered a set of fans from eBay since the support took so long to reply to my mail.

The fans were 30 x 30 x 10mm 12v 0,08A, the same as the ones that came with the Ultimaker 2:

http://www.ebay.com/itm/221393479086?_trksid=p2059210.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT

Ive tried to connect them, but they dont start (I have made sure the fan speed is at 100%, and testet different speeds).

I have also measured the voltage to be about 19 V, but still no movement.

I dont have any power source that I could test the fans with at the moment.

I also may add that the original fan wires that runs along side the feed tube is absolutely garbage. Thin as a hair.

Have anyone else encountered problems with un-original fans?

 

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • Introducing the UltiMaker Factor 4

        Introducing the UltiMaker Factor 4

        ArunC posted a topic in UltiMaker 3D printers,

        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
        MariMakes

        Picked By

        MariMakes,
      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 26 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...