UM2 Question-Does the nozzle separate from the heater block?

[pacebedo 0]

Hi folks,

I just recently ordered the nozzle and heater block for my UM2 because the previous one had jammed to the point of being useless. I swapped them out and it now works pretty well. Anyway, I was trying to pull the nozzle out from the heater block on the old one and could not. I tried a couple of needle nose pliers to no avail. My reasoning is that if I could pull out the nozzle I can just pop in a new one on the old heaterblock.

Your thoughts? Thanks.

 

[IRobertI 521]

No, it's a single part. This thread might be of interest to you:

http://umforum.ultimaker.com/index.php?/topic/7689-custom-heater-block-to-fit-e3d-nozzle-on-ultimaker-2/