Jump to content
Ultimaker Community of 3D Printing Experts
Sign in to follow this  
mmartin

You cannot start a new topic

Recommended Posts

You can't start a new topic until you have validated your email. Check your spam folder for emails from this forum or validate again. To validate there is a huge "validate" button somewhere - I think on your settings page - the page about you:

http://umforum.ultimaker.com/index.php?/user/39131-mmartin/

If you can't figure it out post here and one of the moderators will try sending you an email manually and you can reply to that. But that takes hours.

 

Share this post


Link to post
Share on other sites

Hmm, I could start this topic, but not in the "dual extrusion kit" area. In my profile, it says: "Group: validating". I checked my spam folders, but did not find any email in there - but it might have been deleted because I registered a while ago, but never got a confirmation that it would have been approved by a moderator (which the registration process said would be necessary). I don't see a 'validata' button in the profile either...

Anyway, would there be a specific reason why I could not post to the dual extrusion forum?

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Our picks

    • How to 3D print with reinforced engineering materials
      Ultimaker is hosting a webinar where we explain how you can achieve and maintain a high print success rate using these new reinforced engineering materials. Learn from Ultimaker's Product Manager of Materials and top chemical engineer Bart van As how you can take your 3D printing to that next level.
      • 0 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!