Z moves extruding extra material

[psi3000 0]

I had a problem where when printing a test cube the corners would get extra material and make the corners rounded. I searched the net and found that by lowering the speed of the outershell this fixed the issue.

However, I still have extra material coming out from where it makes the z move up to the next layer. I cannot find anything on the net to remedy this.

I hit "check for update" and it says I have the most current version. I have tried different settings on retraction in basic and expert mode, nothing helps.

Has anyone experienced this.

I have a Prusa i3 running merlin, tuned in.

thanks

 

[dirkdirk 5]

Try cura Version 15.01. There should be the z move done at the infill and not at the outer perimeter.

http://software.ultimaker.com

[psi3000 0]

yes, i just looked at my version and its on 14.09. But it says theres a new version to download today, when i just tried it yesterday. I doubt it went from 14.09 to 15.... but i will try it, thanks for the info!