Waiting for a couple of samples to come through to see what they print like, it's good that their CAD library is available to all.
- 1 year later...
Hi,
I'm interested on tribo-filaments as well. I hope these will give me a better solution to built a fully functional acme screw thread!
Any update on igus filaments?
Brgds
I tried the tribo filament. I was a bit of a pain to have the print stick to the heated glass. I had to use 3DLac spray (something like hairspray).
I printed with a 0.25mm nozzle and in the end it clogged so bad I had to throw the nozzle away :(
Not saying the filament is bad, I was jut too much of a noob to print with it...
Recommended Posts
mcgyvr 2
Never tried their filament but Igus is a great company with some great products in general.
Their plastic bearings/linear slides are great and not too expensive
Link to post
Share on other sites