Jump to content

Restoring Firmware after replacing MCU on Ultimaker 2.1.1 board

craigking96

By craigking96
in UltiMaker Cura

 Share

Recommended Posts

craigking96

craigking96 0

Posted
Posted · Restoring Firmware after replacing MCU on Ultimaker 2.1.1 board

I have just replaced the MCU chip on my Ultimaker 2.1.1 main board and am looking to reload firmware. Can someone provide guidance on installation of the boot loader and firmware? I am familiar with the ISCP interface and have an AVR but I need to know where to pick up the correct boot loader image that will allow me to use Cura to install the most recent firmware.

 

    • Link to post
    Share on other sites
    anon4321

    anon4321 16

    Posted
    Posted · Restoring Firmware after replacing MCU on Ultimaker 2.1.1 board

    Hmmm, I would think it uses the Arduino bootloader for the equivalent Arduino board that has the same MCU since Cura is able to update both the UM2 and UMO. Possibly the bootloader for the Arduino Mega 2560 R3 which is used in the UMO? Is the MCU an ATMEGA?

     

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • Introducing the UltiMaker Factor 4

        Introducing the UltiMaker Factor 4

        ArunC posted a topic in UltiMaker 3D printers,

        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
        MariMakes

        Picked By

        MariMakes,
      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 26 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...