Quote: I just want to find out as I am planning to do some experiments with 'flow' to try and improve the situation I am suffering with, and I just wanted to find out whether these 2 settings basically do the same thing.
What is it you wish to accomplish?
Not sure but willing to try anything. I am just thinking that my problem is under extrusion. And i wonder what will happen if i force a bit more plastic out.
So to so this, i wonder if i should increase the flow, or reduce the filament diameter?
Recommended Posts
swordriff 119
Quote: I just want to find out as I am planning to do some experiments with 'flow' to try and improve the situation I am suffering with, and I just wanted to find out whether these 2 settings basically do the same thing.
What is it you wish to accomplish?
Link to post
Share on other sites