Jump to content

drying time for taulman bridge nylon

lance-greene

By lance-greene
in Coffee corner

 Share

Recommended Posts

lance-greene

lance-greene 7

Posted
Posted · drying time for taulman bridge nylon

So I have been printing a ton of bridge lately and was just wondering what most people use or drying temps and time when they throw it in the oven?I usually let it sit in the over for 2 hours or so every morning when i intend to print with it. keeping it in there at 120 C.

 

    • Link to post
    Share on other sites
    yellowshark

    yellowshark 153

    Posted
    Posted · drying time for taulman bridge nylon

    Sorry I do not know the answer for Bridge but I would just warn that the various Taulman nylons do have different melting points (sorry I have forgotten the posh and perhaps more accurate term). I put some 645 and some T-glasse in the same oven. The 645 was perfect and the new T-glasse (with a lower temp.) was completely ruined. You do not make that mistake twice :)

     

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 18 replies
        MariMakes

        Picked By

        MariMakes,

      • Release Notes: S-Line Firmware 8.3.0 (Latest)

        Dustin posted a topic in Firmware,

        S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...