Z height

[imk 0]

Hello,

I have an STL file that is a single part that I would like into two part (top and bottom)

So is there a way in Cura 15 that I can set the Z height to stop or start generating gcode at.

Many thanks imk

PS if Cura can't it would make a nice addon

 

[yellowshark 153]

Go to the advanced tab, under the Quality section you will see "cut off object bottom". Tell it how many mm you want to cut off and you will see the model sink into the print bed. This sorts the top half. Then the success of the bottom half will depend on the shape of your model; rotate the model 180 degrees about the Y axis and again cut-off the model.

 

[pm_dude 27]

You can also slice the object super easily in netfabb or meshmixer. Both are free

[imk 0]

New it could be done, many thanks all