UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Well I wonder about a couple of things. Firstly your temp. must be too hot. I print Faberdashery red at 30mm/s, layer .200 at 210c; so that is 3X the amount of material at 20c lower.
Also I wonder how you set your print up to reach your minimum layer temp.? What is the temp and what is your infill setting? Also were you using 100%on the fans?
Did you do the under extrusion test with same filament?
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
yellowshark 153
Well I wonder about a couple of things. Firstly your temp. must be too hot. I print Faberdashery red at 30mm/s, layer .200 at 210c; so that is 3X the amount of material at 20c lower.
Also I wonder how you set your print up to reach your minimum layer temp.? What is the temp and what is your infill setting? Also were you using 100%on the fans?
Did you do the under extrusion test with same filament?
Link to post
Share on other sites