Yes, I stopped the print where it was and just moved it on x/y to to do the fan test.
Bed is not heated, printing PLA.
I did not retune the PID, do you have a link on doing that? I assumed it didn't need a retune because it's pretty consistent showing the 220 in my tests above.
my heater is 24v. I assumed it wouldn't be a problem on a 19v system, I just figured it would take longer to heat up.
Recommended Posts
anon4321 16
Did you check the fan at the same distance from the bed as the print test?
Is the bed heated?
Did you retune the PID when you switched to the e3d hotend?
Is your E3D heater 12V or 24V?
Link to post
Share on other sites