Jump to content
Ultimaker Community of 3D Printing Experts

langley51

Member
  • Content Count

    4
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Country
    US

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. I am printing 3d plane parts / fuselage parts and I am getting alot of thin areas with pin holes. I am using ESUN PLA+ , temp is 220 nozzle , bed 60 Layer height: .25 Shell: wall line count 1 Cooling : enabled Fan speed : 30 220 nozzle temp , bed : 60. Infill : 0 Print speed: 50 Travel : enabled retraction Mesh Fixes: union overlapping volumes (checked) Special Modes: Surface mode normal
  2. I have been using Cura 4.8.0 and it has been working good on files from Thingiverse, however now when I work up a file and go to print my nozzle height has changed to a higher level. What settings do I check to see why now my nozzle is higher than before when all other files have printed. Thanks
  3. I worked up a file to print from Cura, went and ran a different file and now my nozzle is too high from table. What would change that from the last file? Thanks
×
×
  • Create New...