Jump to content
Ultimaker Community of 3D Printing Experts

Jdo300

Member
  • Content Count

    3
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. Hi Everyone, I've been trying to print this portafilter dosing cup model (for an espresso machine) https://www.thingiverse.com/thing:4648455 And for the life of me, I've been having problems trying to support the small lip sticking out around the edges without causing issues with the surface quality on the outside of the cup. I'm using Cura 4.6 and currently setup simple supports using the Cross type with walls to keep them from collapsing. The cross type creates four gaps in the support material to allow airflow between the outside walls and support wa
  2. Hello, I'm having a problem printing white NinjaFlex TPU on an Airwolf3D AXIOM Dual Direct Drive printer. I am trying to run some test prints of a face mask ear strap but am having problems with the nozzle clogging shortly after the print starts (within the first 5 or so minutes). What happens is the print will start printing the first layer without a problem, but after printing the brim and the outline of the part, the nozzle starts clogging as it prints the infill for the first layer. I used the recommended profile settings on the NinjaTek product page as a guide for the settings
  3. Hello All, I have two Airwolf3D AXIOM Dual Direct Drive printers that I’ve worked with for several years off and on for small/medium sized prints in ABS and Polycarb. But I’ve always had issues from day one to get good quality part finishes with my printers, to the point where I found myself spending literally hours reprinting parts again and again to optimize the print profile to come out *mostly* decent. In the past day or so, I determined to spend time to look into the problem and really tune the printer to work well with ABS prints (Polycarb and PLA prints generally
×
×
  • Create New...