ThomasRahm

This is just minimum height to model being set to 3mm preventing trees with smaller height from being generated. If you set minimum height to model to 1mm it looks like the attached image.

Initial Layer Diameter does that, just at a fixed 40°. Is there a need to adjust that angle? If yes, why?

@MariMakes Most likely #14302

@nallath You are looking at the wrong branch. The code is in the tree_support_2 branch. This was done so that the readme changes are not part of the draft pull request (where the changes can be examined more easily). I recently updated it to 5.0. @lospo Thanks a lot for the kind words.