That's just how one would expect it to look like, since that area is where the supports were.If you need all the surfaces to look clean, the number one rule is do not use supports. Split your model into two or more parts to avoid using supports, add locating holes on all mating surfaces, print separately and assemble, popping some filament into the locating holes. Use superglue as an adhesive.
If you upload your model I will show you what I mean.
Yea I've been tinkering with some settings as well, the speed the extruder travels when making infills, does that pertain to quality as well? while i watch it, it seems it misses a bit when extruding filament. Not sure if that is supposed to be like that since its just supports that are being made. Would you like me upload the .stl file as well?
Recommended Posts
danilius 118
That's just how one would expect it to look like, since that area is where the supports were.
If you need all the surfaces to look clean, the number one rule is do not use supports. Split your model into two or more parts to avoid using supports, add locating holes on all mating surfaces, print separately and assemble, popping some filament into the locating holes. Use superglue as an adhesive.
If you upload your model I will show you what I mean.
Link to post
Share on other sites