Hello GR5,
thank you for your quick answer! unfortunately I am not an artist at soldering ;-) and as I wrote: a new heated bed may be here on Monday. What I tried to achieve was a kind of shortcut for the weekend. A software solution for switching off the bed completely, so that I can print with the UM2 with PLA. Some kind of detour around the errormessage. But thank you for your hints- I will find someone to solder the parts, if the substitute isn't here on monday.
Recommended Posts
gr5 2,224
First of all this is extremely to fix on your own if you know how to solder - it's usually the little pads at the connector or a loose screw on those smaller wires (the pt100). You can alternatively somehow get around 108 ohms (higher is fine but stay under 200 ohms) across the leads going out to the temp sensor. For example use aligator clips.
Link to post
Share on other sites