Sourcing belts

[jet 0]

Soooo.... my ultimaker snapped one of its long belts a few days ago, I have no idea how this happened, but there is not 1 sleeve of 240mxl belt in all of Australia, so if i want to buy a single 1/4inch belt, I have to pay $70 to get the whole sleeve imported, and it will take upto 2 weeks. Does anyone know somewhere online I can get one and get it express shipped for less than $1,000,000?

[greengecko 8]

Not siure i looked for them a while ago.

Given the spec 300 teeth, 0.25 inch, no clue which enforcement i think you could find them here

http://www.smallparts.com.au/store/part ... /all/2561/

But would be good if someone could confirm the specs.

There have been some reports that 300 teeth are too long and 298 or 297 are better. Does anyone has an idea about this?

[dinac 0]

i order 298 , and cant put on pulley

to short to function machine properly