Jump to content
Ultimaker Community of 3D Printing Experts
kerberg

change speed but time doesnt update?

Recommended Posts

The short answer is: Don't look at the time that is displayed on the machine, trust cura.

Slightly longer answer. The machine estimates the remaining time based on how long a layer takes to lay down and how many remains (I don't know the exact mechanism behind it, it's slightly more complicated than that) which is far from accurate as you might have tiny layers at the start and huge ones at the end or vice versa. cura's estimates on the other hand are usually very close to real time.

Edited by Guest

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!