One part at a time - Cura 15.6.3

[stuart838 1]

Hi All!

I'm having trouble finding the option to print one part at a time on the new Cura (on a mac if that makes any difference).

Tried searching the forum but no joy... Someone point me in the right direction?

Thanks!

-Stu

Edit:

Also... I tried using the older version of Cura just to get this done and I get an error;

 

Info: Print one at a time mode disabled. Object too tall.

 

(The part is very small)

Edited September 2, 2015 by Guest

[stuart838 1]

(Please delete this post)

Edited September 2, 2015 by Guest
posted new rather than edit first post

[Dim3nsioneer 558]

Cura 15.06.x hasn't got that option.

Legacy Cura: The info says it. Your object is too tall for print one at a time mode. The rods would hit the first object when printing the second.

[Strik9 0]

Ah, i was also looking for this option

[stuart838 1]

Ah ok... not in the new one - at least I know I'm not going crazy!

Legacy Cura: Makes sense - the object loads on its end... hadn't thought about the rods hitting the first part! Doh!