flex printing?

[neone 40]

I just found out that I got flex pla instead of the usual pla (I didn't even know this was an option for printing ).

But I already got some ideas though.

are there any considerations to be made before attemting to print in this material? I'm thinking about trying it out soon.

[Labern 775]

its not the easiest to print with and would suggest you use Roberts feeder with the snap on guide. you can also put a drop of oil in the bowden tube.

These are the settings XYZ workshop recommend to print their dress so could be a good start.

Temperature - 230°C

Speed- 10-15mm/s

Sliced at 0.15mm

Retraction - Off

Fan- Off

Masking tape on top of heated bed

[ultiarjan 1,223]

I use "cube stick" as glue for flex pla. Works fine and probably easier than tape...