UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Apart of glue/airspray etc (that obviously work well) you can use a large brim to improve the adhesion. Also raft if what you print has little foots that end losing grip.
It's pretty easy to remove afterwards as you just peel it off.
It can leave a sharp edge but this can also be easily removed with a sharp knife. Hold the knife at 90degees to the print or even slightly backwards so it doesn't dig in and just scrapes off the edge.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
neotko 1,417
Apart of glue/airspray etc (that obviously work well) you can use a large brim to improve the adhesion. Also raft if what you print has little foots that end losing grip.
https://ultimaker.com/en/support/view/16588-expert-settings
Sit and read:
http://support.3dverkstan.se/article/30-getting-better-prints
Link to post
Share on other sites
Labern 775
Add brim is the best method.
It's pretty easy to remove afterwards as you just peel it off.
It can leave a sharp edge but this can also be easily removed with a sharp knife. Hold the knife at 90degees to the print or even slightly backwards so it doesn't dig in and just scrapes off the edge.
Link to post
Share on other sites
neone 40
thanks a lot for the feedback, I'll try a brim next time.
Link to post
Share on other sites
neone 40
the first test worked like a charm!![:)](//content.invisioncic.com/ultimake/emoticons/5a33abdf6d109_1f60acopy.png)
many thanks @neotko and @Labern for the help!
Link to post
Share on other sites