XT is not that easy to print with.
I'm guessing this might be due to changes in speed from the minimum layer time. You could adjust the time a bit.printing a tower next to it or print 2 at once helps but you will need to fix the Stringing first.
Also making all your speeds the same will give better results.
XT is prone to Stringing and you may need to increase the retraction distance.
Recommended Posts
zoev89 73
My 5 cents..
Do you have a UMO with 1 fan? To me it looks like a fan issue. One side the fan cools the material and the other side it does not. You might try to position the part differently so the fan hits both sides.
Link to post
Share on other sites