Any tips for avoiding these ugly strings on the wings? :)

[frederiekpascal 193]

From the start should be fine. if you lower it during the print it will drop passed your set point 5 or so deg until it comes back and stabilizes. you can risk under-extrusion if done that way.

 

and probably for that reason, the bottom layers of my print looked like this...

I changed my settings now

[Labern 774]

bummer. Well hopefully next time its all good.

[LePaul 321]

 

From the start should be fine. if you lower it during the print it will drop passed your set point 5 or so deg until it comes back and stabilizes. you can risk under-extrusion if done that way.

 

and probably for that reason, the bottom layers of my print looked like this...

I changed my settings now

 

"She may not look like much, but she's got it where it counts, kid. I've made a lot of special modifications myself. " - Han Solo

How'd the full print go?

[frederiekpascal 193]

How'd the full print go?

 

I cancelled it in the middle and I'm printing it again now, with 195°C and 30mm/s from the start

Tomorrow it will be finished, I'll post pictures from attempt 5