I guess I should update my firmware.
I'm surprised by the fans. I thought it was a no-fan material like ABS.
Thanks.
I guess I should update my firmware.
I'm surprised by the fans. I thought it was a no-fan material like ABS.
Thanks.
@Labern, one more question.
Should the fans be off for the first layer and then turn on to 50% for layers 2+ ?
Or
Should the fans be on at 50% the whole time?
I normally set the fans to be at 50% on layer 8-10. So they start spinning slowly at layer 3-5 and slowly increase up.
Sometimes if i'm printing really slow and hot i have fans on full but i make them full at 5mm
Please select the answer which helped you most as 'Best Answer'. It will help future readers find the appropriate answer as fast as possible. Thank you!
the profile should be in the new firmware.
235 -250 deg
65deg glass
fans 50%
I have tried, but couldn't find it in the settings. Isn't it released?
I have tried, but couldn't find it in the settings. Isn't it released?
It was added (at the end of the list) in firmware version 14.12 with the name "UPET" and renamed to "CPE" since V15.04.1 (i think...).
But there's also a limit of 16 entries, nothing will change if the limit is already reached.
I have tried, but couldn't find it in the settings. Isn't it released?
It was added (at the end of the list) in firmware version 14.12 with the name "UPET" and renamed to "CPE" since V15.04.1 (i think...).
But there's also a limit of 16 entries, nothing will change if the limit is already reached.
Got my "problem". Cura said "no update available", but this was a problem in the Cura-Version. Got a new version and a new firmware now. Thanks.
Recommended Posts
Labern 775
the profile should be in the new firmware.
235 -250 deg
65deg glass
fans 50%
Link to post
Share on other sites