Jump to content

Feedback During Cura FirstRun Wizard / Checkup


billh

Recommended Posts

Posted · Feedback During Cura FirstRun Wizard / Checkup

Daid,

When I run FirstRun Wizard > Ultimaker Checkup and click the limit switches the only feedback is the prompt to click the next limit switch thus when you click the bottom Z limit switch there is no feedback at all.

Suggestion: An "Limit Switch OK" message after each switch is successfully detected so that the human explicity understands wether or not each of the switches are working.

Thanks, Bill

  • Link to post
    Share on other sites

    Posted · Feedback During Cura FirstRun Wizard / Checkup

    I'm reworking the checkup wizard. I'm almost done with it, and it will be a LOT easier to follow, with clear indications what is happening, better logging, and pictures to show which endstops to press.

  • Link to post
    Share on other sites

    Posted · Feedback During Cura FirstRun Wizard / Checkup

    can i ask you to double check the text in the endstop calibriation. it told me to check the z top endstop, i pushed it, and nothing happened, then i pushed the lower one, and that worked.

  • Link to post
    Share on other sites

    Posted · Feedback During Cura FirstRun Wizard / Checkup

    The text in Cura 12.08 is fine. But it's sometimes a bit slow to react, up to seconds. So that could have been your problem.

  • Link to post
    Share on other sites

    Posted · Feedback During Cura FirstRun Wizard / Checkup

    That does look alot better, I'd also suggest some clarity on what should be done for the steps per E test.

  • Link to post
    Share on other sites

    Posted · Feedback During Cura FirstRun Wizard / Checkup
    That does look alot better, I'd also suggest some clarity on what should be done for the steps per E test.

    I made that test very clear by removing it all-together. It's not really needed to get good results, it's a 1% final tweaking thing that doesn't belong there at all.

  • Link to post
    Share on other sites

    Posted · Feedback During Cura FirstRun Wizard / Checkup

    Daid, Thanks for the quick improvements!

    Best, Bill

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
    ×
    ×
    • Create New...