UM2 - Seaweed Infill Issue

[drofnas 15]

Curious if anyone has seen this before?

I had just did some Atomic cleaning, created a decent print, then the next day this started happening. Was just about to Atomic pull it again, but thought I'd ask if anyone else has seen this issue and if I'm just gonna have to Atomic'ly clean my hot end before every print?

I did just order a Olsson Block, should be here this weekend. So maybe that will help clean up my issue. But I would like to make sure I have a working backup hot end just incase

[ultiarjan 1,223]

If your walls are ok my first guess is your infill speed is to high so check your settings and try to print infill slower.

[drofnas 15]

I shall try that, for now I just changed over to the Colorfabb Blue Grey PLA filament, from the Ultimaker Transparent PLA stuff I was using. Just using the "Normal" printer settings from Cura again, so we'll see how this print I'm doing now turns out.

[DidierKlein 729]

I would bet on infill speed to high?

[stu_le_brew 42]

I have seen exactly that recently - caused by too fast infill speed as others have suggested