Owen,
Thanks for the suggestion. I did change it on the fly to 50% speed, and didn't see any difference.
Perhaps that doesn't effect the predefined print speed, but only the "global" speed. I'll try a slower print at 260C (Can't go any higher on UM2).
Recommended Posts
owen 19
Hi
Your infill speed is 50mm/s compare to 30mm/s for inner and outer shells.
So drop that back to 30mm/s and see how you go.
That is a very small nozzle size so if you still have any under extrusion try slowing your speed down more or increasing your nozzle temp.
Good luck
Owen
Link to post
Share on other sites