UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
SG91 0
Kinda off topic but, can some1 help me change gcodes?
Would like to do this
1. If possible remove the auto home function just before it goes to do A skirt?
Im abit bored of having to restart 1-2times cos of oozed filament get squished around
the nozzle. And messes around with it at the print zone.
2. Automatic 210c first layer then go down/up to the temp I choosen in cura.
3. At the end to make it stay at idle temps 150c + bed 60 after.
Edited by GuestLink to post
Share on other sites