Cura plugin Skip infill

[Predator75 0]

Hi,

is it possibile to upgrade the plugin Skip Infill to apply to the Bottom/Top layer also?

regards

Cristian

[nallath 1,123]

You could just set the infill to 0% (and top/bottom thickness to 0 as well)

[Predator75 0]

Thank you I'll try!

[Predator75 0]

ok if I set top/bottom tickness to 0, the layer wil not printed. where I wrong?

[nallath 1,123]

I might have understood you incorrectly, but you asked for skipping the infill for bottom/top layer and the solution i gave you is how you do that.

[Predator75 0]

Thank you nallath, and sorry for my bad english, my fault.

There is the plugin named "skip infill" here http://wiki.ultimaker.com/CuraPlugin:_Skipinfill

that print to fill every "n" layer. so for example, I can print 0.1 but infill 0.2 it's ok?

it works with bottn and top layer also?

Is that plugin compatibile with cura 15.04.x ?

is it possibile to view a preview result?, because in preview if I use tha plugin the preview layer don't change

Excuse my bad english

Cristian

Edited February 1, 2016 by Guest

[nallath 1,123]

I've never worked with that plugin, so I don't know how it works / should work.

[Predator75 0]

ok I do same 3D prints for test, I think this best the way

Thank you anyway

Cristian