Jump to content

M300 gcode?


Shipbrook

Recommended Posts

I decided to give OctoPrint a try, and have been having fun adding custom controls for various things (especially the "tune" features that aren't available from the front panel when printing via USB).

I'm working on a set of buttons to make atomic pulls more convenient, and I would like to have the printer beep when the hotend reaches its target temperatures, so I don't have to sit there watching the numbers. The Ultimaker 2 with Marlin firmware (which I have) is supposed to support the M300 ("play beepsound") command, and there are several hits on Google where people indicate that they're using M300 with their Ultimakers (for notifying them when it's heated up, playing tunes when a print is finished, and so on).

However, when I send an M300 command to the printer (e.g. M300 S440 P250 for a quarter-second 440 Hz tone), it returns an "ok" response, so I know it received it, but it doesn't actually make any noise. The printer does make sounds when I use the jog wheel, so is there anything special I need to do to enable it to respond to the M300 command?

  • Link to post
    Share on other sites

    Posted (edited) · M300 gcode?

    its not helping you, but I just tried on mine, USB from S3D and directly from SD card, but mine also does not beep :(

    and I like the idea... I forgot a few times that i was heating up the printer .....

    Edited by Guest
  • Link to post
    Share on other sites

    Posted · M300 gcode?

    its not helping you, but I just tried on mine, USB from S3D and directly from SD card, but mine also does not beep :(

     

    Maybe they took that capability out of the firmware, then. Pity. I suppose I could make noise by moving the build platform up and down a couple of times instead.

  • Link to post
    Share on other sites

    Posted · M300 gcode?

    Maybe this helps

     

    Thanks. That's actually one of the the sources I used when trying to get sounds into my custom control scripts - but it's not working for me.

  • Link to post
    Share on other sites

    Oh :(

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
    ×
    ×
    • Create New...