Jump to content

UM2 firmware or display problem


GabrielNeves

Recommended Posts

Posted · UM2 firmware or display problem

Hi guys,

here is my problem: my UM2 doesn't show nothing on display when I turn it on. Also the motors make a quick noise and repeat it again every 5 secs.

I uploaded the firmware (available on github.com/Ultimaker/Ultimaker2Marlin) using Arduino IDE, and the Serial Monitor shows me 1.0.0 in Marlin version. I can not upload the firmware by the Cura 15.04.5, it shows me the following error:

 

Failed to upload firmware:This firmware is not compatible with this machine.Trying to install UM2 or UMO+ firmware on an UMO?

 

I checked all the voltages (3V3, 5V and 13V) in UltiController rev 2.1 (white electronics) and it's all OK. The LEDs and buzzer are also OK on this board.

Does anyone have any idea that I can try before I buy another display to see if it works? Or it can be a firmware problem?

Thanks.

  • Link to post
    Share on other sites

    Posted · UM2 firmware or display problem

    Have you made sure that you've selected the correct machine in the settings in cura?

    I haven't heard of this error message before so I'm wondering if that's a new check implemented in 15.04.5 and it's choking on the firmware you tried to install from github. You could try using an older version of cura and see if that works (you can have several versions of cura installed at once).

  • Link to post
    Share on other sites

    • 2 months later...

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 26 replies
    ×
    ×
    • Create New...