Offset of the y -axis during printing.

[GOO 0]

Hello there,

I have a UltiMaker Original Plus and i''m having problems during printing.

During printing, after approx. 1 hour printing the y coordinate is displacing.

I have checked all the axis and pulles and this doesn't cause the problem.

Does anyone know's what causes this problem and how to solve it?

I hope to hear from you.

[neotko 1,417]

Did you check also the pulleys on the motors? Also check if the belts have any oil, if so clean with alcohol.

[Labern 774]

It can sometimes be due to the steppers getting to hot or if you have a travel speed to high.

You can prove if any of the pulleys are slipping buy marking the shafts and pukkeys and checking them after it has skipped. If this is ok and it's always after about 1 hour I would think that they are over heating.

[GOO 0]

Hi Labern

i check the pulleys they didn,t slip

Used a extra cooling fan on the steppers problem solved

many thanks

[Labern 774]

Hi Labern

i check the pulleys they didn,t slip

Used a extra cooling fan on the steppers problem solved

many thanks

 

Sounds great. Happy printing.