Someone please tell me the standard retraction settings!

[mayo77 5]

I was fooling around with my retraction settings and i just want to revert back to how it was set up before it worked much better.

These are the setting i want to know

Edited June 9, 2016 by Guest

[mayo77 5]

..added to main post

I figured out the answer myself by installing cura on a separate computer, since this forum was taking too long to answer.

The answer if anyone wants to know the defaults are

min travel - .7

enable combing - all

minimal extrusion - .02

Z hop - 0.0

Edited June 9, 2016 by Guest

[IRobertI 521]

since this forum was taking too long to answer

 

I don't think you can expect a sub 30 minute response time when posting late night US time and early morning EU time...