ZigZag extrusion between wall and infill

[amagro 3]

Hi,

Is there any option to avoid Cura (15 or 2) to stop doing the zigzag extrusion between the walls and the infill?

Tks

[Labern 774]

Is the wall vertical? Or on a angle?

[nallath 1,123]

Probably at an angle.

[amagro 3]

In this case is at an angle.

As you can see in the imagens, there is a lot of overlapping toolpath extrusion in only one layer, this will cause some problems in the shell of the prints, if I increase the print speeds.

I think if we could uncheck the zigzag extrusion, we could have better prints for higher speeds.

Edited August 9, 2016 by Guest

[Labern 774]

The zig zags that you are talking about are top/bottom layers. As the side wall is on an angle it lays a small section of a top or bottom layer in the area covering the amount of angle.

(Don't think I explained that well)