You have underextrusion. What material is this? PLA? Usually PLA doesn't peel off like that but that's common with ABS and easily fixed.
Still - what material is this and what temperature (temperature is set on the printer, not in cura).
I think the default temp is 210C and assuming PLA and with .3mm layer times .4mm nozzle times 50mm/sec that equals 6mm^3/sec. That's a bit fast for 210C and PLA. Try raising the temp to 220C and making your layer height thinner - try .15mm also slow it down a bit to 35mm/sec. That should fix much of the quality problems.
I used a PLA not ABS. I try your settings.Thank you
Recommended Posts
gr5 2,224
You have underextrusion. What material is this? PLA? Usually PLA doesn't peel off like that but that's common with ABS and easily fixed.
Still - what material is this and what temperature (temperature is set on the printer, not in cura).
I think the default temp is 210C and assuming PLA and with .3mm layer times .4mm nozzle times 50mm/sec that equals 6mm^3/sec. That's a bit fast for 210C and PLA. Try raising the temp to 220C and making your layer height thinner - try .15mm also slow it down a bit to 35mm/sec. That should fix much of the quality problems.
Link to post
Share on other sites