UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Posted
(edited)
· Bed Leveling with Cura 2.1 and UMO+
That is not a stupid question at all :-)
There is actually only one way to do it in Cura 2.1, and it is not very obvious, since it requires you to add the machine again and do the bed leveling trough the setup wizard.
This is a known issue and will be fixed in Cura 2.2 where this button will be found in the "manage printers" window:
Thanks meduza! I figured I could do it that way, but it seemed awkward. Until Cura 2.2 is released, I will continue to use 15.04.06 for the bed leveling function.
1
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
Recommended Posts
meduza 191
That is not a stupid question at all :-)
There is actually only one way to do it in Cura 2.1, and it is not very obvious, since it requires you to add the machine again and do the bed leveling trough the setup wizard.
This is a known issue and will be fixed in Cura 2.2 where this button will be found in the "manage printers" window:
![Rv5oIK2.png](http://i.imgur.com/Rv5oIK2.png)
Edited by GuestLink to post
Share on other sites
rowiac 53
Thanks meduza! I figured I could do it that way, but it seemed awkward. Until Cura 2.2 is released, I will continue to use 15.04.06 for the bed leveling function.
Link to post
Share on other sites