Thanks I tried and just needed to adjust temp to 215 , works quite well
90% of "3mm filament" is actually 2.85 to 2.9mm.
If you measure it as 3.00mm or larger with calipers - it will very likely get stuck in the bowden at some point. You will have to remove the bowden at both ends and cut the filament at both ends, then heat the whole thing in hot water until it slides out.
I used it and worked fine. Thanks for your help.
-
Our picks
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 3 replies
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Picked By
MariMakes, -
-
UltiMaker Cura 5.7 stable released
ArunC posted a topic in UltiMaker Cura,
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
-
-
- 26 replies
Picked By
MariMakes, -
-
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Recommended Posts
Labern 774
It may work but its not advisable as the tolerance of 3mm filament can mean that it ends up larger then 3mm and you will end up with all sorts of issues.
Most manufacturers make 2.85mm but advertise it as 3mm so just check with them what the actual size of the filament is.
Link to post
Share on other sites