Installing custom Firmware

[ScruffyWelder 2]

Hi folks,

I've just fitted a Bondtech extruder, and an Olsson block kit to my Ultimaker 2.

I now need to change the firmware to suit the new extruder.

I've been using Cura 2.x until now because I cannot get any earlier versions of Cura to run on my laptop (just freezes on the opening banner).  

Unfortunately Cura 2.x doesn't allow for custom firmware....

What can  I do to get the new firmware into the printer?

Is there a workaround?

I'm no computer or code expert, so don't know how to edit code etc.

I've also got a copy of Simplify3d if that's an option

Thanks in advance

Simon

Edited October 5, 2016 by Guest

[neotko 1,417]

Download Cura 15.xx and upload custom firmware

Edited October 5, 2016 by Guest

[ScruffyWelder 2]

Download Cura 15.xx and upload custom firmware

 

Thanks, but I can't get Cura 15.xx to run on my laptop. Always freezes on the opening banner

[neotko 1,417]

Then get into cura folders, search for your model .hex file and replace it. This way it will update with your file. Ofc, remember to backup the real firmware just in case

[ScruffyWelder 2]

Then get into cura folders, search for your model .hex file and replace it. This way it will update with your file. Ofc, remember to backup the real firmware just in case

 

Okay, so this sounds like voodoo to me.....

Is it a case of simply adding my new firmware into the correct folder then renaming the (new) file to that of the original firmware?

[neotko 1,417]

Yeah exactly

[ScruffyWelder 2]

Well that appears to have worked...

Thanks neotco

Only problem is the extruder is running backwards...

I'm in touch with Martin at Bondtech and we will get it sorted

Thanks again

[ahoeben 1,963]

The final 2.3 will support uploading custom firmware (I am not sure if the official 2.3 betas already do).