UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Posted
· 3d Printing designs not printing smoothly
You need a lot more top/bottom layers. you set it to 0.4 with 0.2 layer height. So you only print 2 top layers, thats not enough for a smooth surface, you need minimal 6, so 6 x 0.2 = 1.2 mm top/bottom layers, some people prefer even more....
And check you cooling, I assume you print PLA? set your fans too 100%
And check here for some additional support, have a look at the trouble shooting guide.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
ultiarjan 1,223
You need a lot more top/bottom layers. you set it to 0.4 with 0.2 layer height. So you only print 2 top layers, thats not enough for a smooth surface, you need minimal 6, so 6 x 0.2 = 1.2 mm top/bottom layers, some people prefer even more....
And check you cooling, I assume you print PLA? set your fans too 100%
And check here for some additional support, have a look at the trouble shooting guide.
http://support.3dverkstan.se/
Link to post
Share on other sites